1021XRT 2W Non-Inverted Block Upconverter Type F
RF Output Frequency: 14.0-14.5 GHz. Non-inverted. Output Power @P1dB: 2W (33 dBm). IF Frequency: 950-1450 Mhz. Input Connector: Type F Female. Output Interface: WR75 Waveguide Flange. Power Requirement: +14.5 to +24VDC . Power Consumption: 26W. Weight: 1.4 kg (3.0 lb)
Norsat Block Up-Converters offer state-of-art performance and reliability in a small, lightweight, package for demanding VSAT applications, such as:
- Point-of-Sale and Inventory Control
- Information/Data Distribution and Access
- Telecommuting and Tele-Education
- Portable, Monitoring and Emergency Communications
- DVB Network return paths
Norsat Advantages
- Small, lightweight package for low-cost, direct-to-feed mounting
- Low in-Band noise emissions for up to 100 times improved system capacity
- Power efficient for remote site applications
- Single cable L-Band Interface with 10MHz reference and 14.5-24 VDC power supply for simple installation
- Next generation single RF board design and advanced MMICs for greater reliability
- 30 dBm (1010XRT) and 33 dBm (1020XRT) minimum output power under all operating conditions for reliable uplink performance
- Temperature compensated gain control for constant performance over dynamic conditions
- Integrated lock detector shuts off transmitter in the event of cable cut or IDU failure for safe, compliant operation
- Manufactured in Japan
- CE and ETSI EN 301 428 (2000-05) compliance for global applications
| Manufacturer | Norsat |
|---|
General Specifications | |
|---|---|
| Input Frequency Range | 0.95 - 1.45 GHz |
| Input Impedance | 50 Ohms |
| Output Frequency Range | 14.0 - 14.50 GHz |
| Output Power P1dB | 30 or 33 dBm minimum |
| Nominal Gain | 53 dB ± 4dB @ 23°C |
| Input VSWR | 2:1 |
| Gain Stability over temperature | ± 2 dB at any constant frequency |
| Gain Stability in-band at any constant temperature | ± 0.75 dB in any 54 MHz band ± 2.5 dB over full 500 MHz band |
| Phase Noise (SSB) Maximum | < -30 dBc/Hz at 10 Hz < -60 dBc/Hz at 100 Hz < -70 dBc/Hz at 1 kHz < -80 dBc/Hz at 10 kHz < -90 dBc/Hz > 100 kHz |
| Integrated Phase Noise | < 2.8°MS Double Sideband (10Hz-1MHz) |
| In Band Noise Emissions SSPA ON | < -90 dBm/Hz |
| LO Frequency | 15.45GHz |
| Spectral Inversion | Inverting |
| External Reference Frequency | 10 MHz |
| External Reference Level | -5 to +5 dBm |
| Recommended 10MHz External | -135 dBc/Hz @ 100Hz |
| Reference Phase Noise | 140 dBc/Hz @ 1kHz -150 dBc/Hz @ 10kHz |
| DC Power | 14.5 to 26 VDC |
| Power Consumption | < 26 W |
| Input Connector | 4 hole flange mount N-Female |
| Output Waveguide | WR-75 (Isolator) |
| Size (mm) | 160(L) x 124(W) x 52(H) |
| Mass | 1.6 kg |
| Operating Temperature | -40°C to +55°C |
